시수 | 제목 | 학습 | 자료 |
---|---|---|---|
1 | tool / solid creation 1 - box, sphere, cone, pyramid | ||
2 | tool / solid creation 2 - paraboloid, tube, torus, pipe | ||
3 | tool / solid creation 3 - extrud solid-slab from polyline | ||
4 | surface tool / fillet surface(예제), extand surface(예제), chamfer surface | ||
5 | surface tool / variable radius suface fillet | ||
6 | blend surface용 예제 | ||
7 | blend surface 서피스 연결하기 | ||
8 | blend surface용 복잡한 예제와 적용 | ||
9 | offset surface, 콘트롤 포인트의 조절, connect surface | ||
10 | symmetry, 두개의 서피스 사이에 단계를 만들기 | ||
11 | control point,knot, UV의 개념 익히기 | ||
12 | degree(차수)개념, rebuild curve로 curve 조절 | ||
13 | rebuild surface로 서피스 조절, rebuild surface UV 로 방향 바꾸기 | ||
14 | refit surface to tolerance로 공차값 줄이기, change surface degree | ||
15 | untrim으로 서피스 내부를 복구하기, shrink suface trim | ||
16 | replace surface edge, unroll developable surface와 치수 기입 | ||
17 | flatten surface, smash, adjust surface end bulge | ||
18 | zebra analysis와 curvature analysis로 연속성 확인 | ||
19 | solid tool / boolean 기능 익히기 | ||
20 | merge two coplanar faces, unjoin 명령 | ||
21 | wire cut으로 솔리드 파내기, agline 명령으로 정렬 | ||
22 | move face,extrude face, 솔리드를 control point로 변형하기 | ||
23 | 예제로 정리하기 1 - 드라이기 송풍구 모델링 | ||
24 | 예제로 정리하기 2 - 모종삽 모델링 |
Copyright(C) 2018 생각공장
All rights reserved.